Type Filter Holding Frame

Filter Holding Frames are used in filter banks to house primary and/or secondary filters.
 
These frames are constructed from 1.2mm galvanised sheet steel with four die-punched holes on each side to allow for easy installation. Stainless steel is also available on special request.
 
The holding frames also come complete with two filter holding clips and gasketing.
 

Share page

Recommend this page

Recommend this page by sending a link by mail.

Fields marked with an (*) are required fields.

Share page

Thank you for your recommendation!

Your recommendation has been sent and should arrive shortly.


Contact

We are here for you

Visual contact Visual contact

Please specify your message and type of request.
Tel.: +27 33 3981006

Fields marked with an (*) are required fields.

Contact

Thank you for your message!

Visual contact Visual contact

Your message is send and will be processed shortly.
Our department for Service-Requests will contact you asap.
For general question regarding products or services you can also call:
Tel.: +27 33 3981006

Contact

We are here for you

Visual contact Visual contact

Please specify your message and type of request.
Tel.: +27 33 3981006

Attachment (max. 10MB)

Fields marked with an (*) are required fields.

Contact

Thank you for your message!

Visual contact Visual contact

Your message is send and will be processed shortly.
Our department for Service-Requests will contact you asap.
For general question regarding products or services you can also call:
Tel.: +27 33 3981006